ZEST BOLT Service Manual

AIR CONDITIONING 10 11.5.2 REMOVAL AND REFITMENT OF CABLES FROM HVAC Removal of cable 1. Push the Bowden clip removing it. 2. Then remove the cable coil from the respective cams. REFITMENT OF CABLE Follow reverse procedure to refit. WARNING: Put the cable with white tag in white gear and the black cable in black gear. 1. For Air Distribution Cable : While assembly of Bowden cable knob should keep on face mode. For Temperature Cable: The temperature knob should be in full cold position while assembling the cable. 2. For Air Distribution Cable : Put the eyelet in distribution cam. For Temperature Cable: Put the eyelet in mixing cam. 3. Push the cam by one hand and assemble the cable clip, as shown in the figure. 4. For Confirmation of correct fitment, check by rotating the knobs in extreme position. If the knob is not completing the stroke or the knob is retracting back, above fitment is not correct. Please repeat. 11.5.3 REMOVAL OF WIRING HARNESS CONNECTORS FROM CONTROL PANEL 1. For removing the connector press the snap and pull the connector outside. 2. For removing the connector 2 press the snap and push the lever.