ZEST BOLT Service Manual

SRS 16 10.6.3 PASSENGER AIRBAG (PAB) MODULE Removal 1. Disconnect battery and wait for 2 minutes. 2. Remove dashboard. (Refer Dashboard removal procedure / Body group of BOLT) 3. Remove four mounting bolts of PAB module. 4. Take out PAB module. Installation 1. Insert the PAB module into the dashboard. 2. Tighten mounting bolts of PAB module to specified torque (0.9 - 1.4 Kgm) 3. Assemble the dashboard on the vehicle. 4. Connect electrical connector of PAB module. 5. Reconnect battery. 6. Connect diagnostic tool and clear all fault codes. 10.6.4 SRS ECU Removal 1. Disconnect battery and wait for 2 minutes. 2. 2. Remove floor centre console. 3. Disconnect electrical connectors of SRS ECU. 4. Remove all 3 mounting fasteners of SRS ECU and take it out. Installation 1. Locate the ECU within the 3 studs provided on the tunnel. Check the stud integrity for cracks, breakage etc. 2. Tighten all mounting fasteners of SRS ECU to specified torque (0.9 Kgm). Do not over tighten as there is a risk of the mounting stud breaking due to additional torque. 3. Connect all electrical connectors of SRS ECU. 4. Install floor console. 5. Reconnect battery. 6. Connect diagnostic tool and clear all fault codes.