ZEST BOLT Service Manual

SUSPENSION 32 6.9.1.3 INSTALLATION OF REAR SHOCK ABSORBER AND COIL SPRINGS: 1. Refit the shock absorber top mounting fasteners with new nylon nut in the luggage compartment and tighten to 2.5 to 3 kgm Torque as shown in Figure. 2. Fit and rotate the top rubber with the coil spring. 3. Position the coil spring assembled to top rubber over the torsion beam such that the coil spring lower paint mark coincides with the torsion beam spring pad paint mark as shown in Fig. 4. Raise the torsion beam using hydraulic jack so that the coil spring gets compressed and shock absorber sits exactly over torsion beam properly. 5. Refit and Torque Rear Shock Absorber Bottom Fastener.( as per torque table). 6. Refit the rear wheels. 7. Remove the Car from 2 Post Lift.