ZEST BOLT Service Manual

Automated Manual Transmission 38 Pipe from Pump to Hydraulic Speed Selec- tion Actuator Unit Fitment: Put the pipe from the pump to the hydrau- lic unit back in position and tighten the connectors Assemble the pressure accumulator on hy- draulic actuator unit. Refill the electro-hydraulic selection gear- box hydraulic control system, with reference to:  Hydraulic system fluids for gearbox with hydraulic selection – check level and top up if necessary. Connect the Battery connections and re- move the battery support / drip tray. Connect the diagnosis equipment and carry out the following operations:  Hydraulic system for gearbox with hy- draulic selection – Bleed air.  Clutch self-calibration enablement.  Grid self tuning - service.  New actuators (only if the hydraulic actu- ation unit is being replaced). Pipe from Hydraulic Speed Selection Actua- tor Unit to Fluid Reservoir Removal: Disconnect the Battery connections and remove the battery support / drip tray. 1. Loosen the bands and remove the pipe from the electro- hydraulic selection hy- draulic actuation unit to the fluid reservoir. Proceed very carefully when removing the pipe in order not to damage the angular connector. Pipe from Hydraulic Speed Selection Actua- tor Unit to Fluid Reservoir Fitment: Place the pipe from the electro-hydraulic se- lection hydraulic actuation unit to the fluid reservoir in position and tighten the bands. Refill the electro-hydraulic selection gearbox hydraulic control system, with reference to:  Hydraulic system fluids for gearbox with hydraulic selection – check level and top up if necessary. Connect the Battery connections and re- move the battery support / drip tray. Connect the diagnosis equipment and carry out the following operations:  Hydraulic system for gearbox with hy- draulic selection – Bleed air.  Clutch self-calibration enablement.  Grid self tuning - service.  New actuators (only if the hydraulic actu- ation unit is being replaced).