SAFARI BSVI - SERVICE MANUAL

ELECTRICAL 190 Step 13: In vehicles with no HMI screen, on activation of reverse gear, if a continuous beep is heard for one second followed by no beep for one second, then the sensors are connected properly and the system is working fine. If not, then check DTCs again and do the re-fitment, if necessary. Note: 1. While assembling, if sensor falls on concrete surface from above 1 meter height, do not use that sensor for fitment 2. Due to any damage if holder comes out of the bumper, then replace with new bumper. The view of rear bumper after proper installation of sensors as: "Rear Park Assist System Architecture without Controller (Through BCM)