SAFARI BSVI - SERVICE MANUAL

SUSPENSION 31 Installation 1. Mount anti roll bar but do not tighten the bolts. Align paint mark with bush face to centralize anti roll bar. 2. Ensure ball joint face (a) of anti-roll bar link is parallel to mounting face of anti-roll bar (b). 3. By holding the hex on the shank of the ball joint with a spanner, keep on tightening the lower nyloc nut till the threads protrude about 6 to 7 mm out-side the nut. 4. Tighten anti roll bar mounting clamp bolts. NOTE: Front ARB to be tightened in ECIE / Preload condition. 18. REMOVAL AND ASSEMBLY OF REAR DAMPER ASSEMBLY AND COIL SPRINGS 1) Lift the car using two-post lift. 2) Remove Rear Wheel. 3) Position the hydraulic jack below the knuckle of cross beam in such a way that it slightly compresses the spring. 4) Loosen rear Damper Assembly bottom fastener. 5) Similarly carry out the above steps for the other side.