SAFARI BSVI - SERVICE MANUAL

KRYOTEC ENGINE 110 M. OIL PRESSURE REGULATOR REMOVAL 1. Disconnect and isolate the negative battery cable. 2. Remove the support and lower the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure). 3. Remove the right front tire and wheel assembly (Refer to 22 - Tires and Wheels/Removal and Installation). 4. Remove the right wheel house splash shield (Refer to 23 - Body/Exterior/SHIELD, Splash/Removal and Installation). 5. Remove the serpentine belt (Refer to 07 - Cooling/Accessory Drive/BELT, Serpentine/Removal and Installation). 6. Remove the vibration damper (Refer to 09 - Engine/Engine Block/DAMPER, Vibration/Removal and Installation). 7. Disconnect the oil pressure regulator wire harness connector (1). 8. Remove the bolt (2a) and oil pressure regulator (2b). FITMENT 1. Replace the oil pressure regulator (1) and clean and inspect the inlet screen (3). 2. Using a NEW O-ring seal, Install oil pressure regulator and tighten the bolt to the proper (Torque Specifications). 3. Connect oil pressure regulator wire harness connector. 4. Install the vibration damper (Refer to 09 - Engine/Engine Block/DAMPER, Vibration/Removal and Installation). 5. Install the serpentine belt (Refer to 07 - Cooling/Accessory Drive/BELT, Serpentine/Removal and Installation). 6. Install the right wheel house splash shield (Refer to 23 - Body/Exterior/SHIELD, Splash/Removal and Installation). 7. Install the right front wheel and tire (Refer to 22 -Tires and Wheels/Removal and Installation). 8. Remove the support and lower the vehicle. 9. Connect the negative battery cable.