ARIA

ENGINE 38 C. POWER STEERING PUMP BELT (STRETCH BELT) The stretch belt used in this vehicle is multi ribbed belt. This belt is pre-tensioned over power steering pump and crank shaft pulleys and therefore do not require the tensioner as this is capable of efficient power transmission. ! CAUTION The stretch belt is not interchangeable and should not be interchanged with normal V-ribbed belts . STRETCH BELT REMOVAL Remove the stretch belt from vehicle using stretch belt removal tool 2702 5890 0623. ! CAUTION Stretch belt should not be reused. Once removed it should be replaced by new one. FITMENT 1. Install the new stretch belt on power steering pump pulley. 2. Align the belt with the crank shaft pulley and hold the belt with the mounting tool (Part no. 2702 5890 0622) and rotate the crank shaft pulley clockwise. ! CAUTION Ensure that the tool is correctly located during the belt fitment process.Make sure that while rotating the crank shaft pulley the belt should not slip away from power steering pump pulley. D. ALTERNATOR AND AC BELT ALTERNATOR AND AC BELT REMOVAL 1. Remove the power steering belt (stretch belt) by cutting the same. NOTE Do not reuse the power steering pump belt once re- moved. 2. Remove the tensioner cap (1) and loosen the tensioner bolt (2). 3. Reduce the belt tension by rotating the tensioner screw (3) in clockwise direction (Tightening direc- tion of a RH threaded screw) and remove the belt. INSPECTION Inspect the Alternator belt for wear, cracks and signs of failures. Replace if necessary.