ARIA

ENGINE 92 2.1.3.5 ENGINE ASSEMBLY 1. Measure piston projection above crankcase with the help of piston topping dial gauge. 2. Based on the piston projection / protrusion values above crank case, select correct thickness of cyl- inder head gasket. Refer the table. Piston Projec- tion (mm) Gasket Thick- ness (mm) Identification 0.56 to 0.64 1.3 1 Notch 065 to 0.73 1.4 2 Notches 0.74 to 0.82 1.5 3 Notches 3. Install cylinder head on cylinder block by locating the dowels properly. 4. Tighten the cylinder head mounting screws to specified torque in the proper sequence as shown below. 5. Install the roller finger follower and hydraulic lash adjuster assemblies. NOTE • Do not assemble spongy HLA’s. • Refer lubrication section for inspection details.