HARRIER SERVICE MANUAL PART -1

BRAKES 50 REMOVAL AND REFITMENT OF TANDEM MASTER CYLINDER (TMC) & BOOSTER ASSEMBLY REMOVAL 1. Position vehicle on two post lift and disconnect battery. 2. Drain the brake fluid from the brake circuit. (For procedure refer brake fluid draining in this section.) 3. Disconnect the electrical connector of brake fluid level switch. 4. Disconnect vacuum hose from brake booster. 5. Remove the spring band clamp at the CMC end and hold the CMC to reservoir connecting hose in vertically upward position to avoid any further loss of fluid and plug the openings with suitable cap. 6. Loosen coupling nuts and disconnect hydraulic lines attached to TMC. 7. Loosen and remove the mounting nuts and remove the TMC assembly from the vehicle. FITMENT For fitment follow reverse procedure of removal. TMC mounting nuts tightening torque 1.8±0.3 Kgf- m.