HARRIER SERVICE MANUAL PART -1

BRAKES 34 E. BRAKE FLUID DRAINING PROCEDURE 1. Open the bonnet. 2. Remove the spring band clamp at the CMC end and hold the CMC to reservoir connecting hose in vertically upward position to avoid any further loss of fluid and plug the openings with suitable cap. 3. Open the bleed screw of front caliper (LHS), connect the bleed tube to the bleed screw and place the other end of bleed tube in the container. Now drain the brake fluid from the hydraulic circuit by pressing the brake pedal repeatedly through its full stroke. NOTE Do not reuse the same drained fluid at the time of bleeding. Follow the same procedure of draining for other three calipers in the sequence given below:  Front caliper (RHS)  Rear caliper (LHS)  Rear caliper (RHS) F. BRAKE LIGHT SWITCH ADJUSTMENT 1. Place the brake pedal in release position. 2. Loosen the lock nut. 3. Adjust the brake switch till the gap between the brake switch and the switch stopper on the brake pedal is 2 mm. 4. After confirming gap tighten the lock nut.