HARRIER SERVICE MANUAL PART -1

SUSPENSION 27 13. ON BENCH REMOVAL AND ASSEMBLY OF WHEEL HUB 1. Remove the knuckle Assembly from vehicle.(Refer Front suspension removal Procedure) 2. Remove circlip from knuckle. 3. Remove Hub Assembly using press & Tool Required. 4. Remove inner race of bearing from the hub. ASSEMBLY: 1. Follow the above steps in reverse order in appropriate sequence for its assembly. NOTE: High / Low point matching on Hub and Disc Observe the condition of disc surface. If the disc surface is smooth ensure that punch mark (Low Point) on disc and hub (High Point) are aligned and assembled. If the disc surface is uneven showing rough marks, grooves - machine it to the specified limit; measure the run out on dia 220 w.r.t. hub and disc resting face. Punch mark around bolt hole where run out on dia 220 is at low point. Align low point on disc and high point on hub while assembly. Assemble with countersunk screws. 2. Tighten the heat shield screw to 0.9 kg-m. 3. Tighten drive shaft nut 30 ± 1.5 kg-m torque and lock by staking. 4. Ensure that oil seal in transaxle is not damaged while fitting drive shaft. PRECAUTION: Use a new hub bearing and new circlip, oil the bearing housing in knuckle carrier and hub itself. Old bearing, even if serviceable cannot be reused. SUB ASSEMBLY - KNUCKLE / HUB: Clean all the parts thoroughly and replace damage / worn out parts. 1. Fit bearing in the knuckle 2. Fit circlip. 3. Place the knuckle assembly over the hub. Press the knuckle assembly on the hub.