SAFARI

31 BODY 11. REMOVAL/INSTALLATION OF WINDOW WINDING REGULATOR (Fig. 14, 15 & 16) REMOVAL l Remove the inner trim l Pull out required portion of plastic membrane. l Remove the window glass l Removemounting screws/nuts of windowwinding regulator i.e. 2 hex fl. nuts from top mounting for front door (1 nut for rear door), 2 hex. fl. screws from bottom mounting and 3 hex. fl. nuts from motor mounting. l Remove the window winding regulator carefully. INSTALLATION l Locate window regulator in the door in proper position. l Fit and tighten the window regulator mounting screws and nuts i.e. 2 hex. fl. nuts (M6) and washers (A6.4) on the top mounting for front door (1 nut and washer for rear door), 2 hex. fl. screws (M6x12) for the bottom mounting and 3 hex fl. nuts (M6) for motor mounting. l Fit the window glass. Ensure correct position of the glass. If not loosen the top mounting nuts and bottom mounting screws of regulator and adjust regulator for proper position of the glass. l Tighten the regulator mounting nuts/screws. l Fix the plastic membrane l Fit the inner trim. Fig. 14. Fig. 15. 1 1. MOUNTING NUTTOP 2. WINDOWWINDINGREGULATOR 3. MOTORMOUNTINGNUTS 4. MOUNTINGSCREWS BOTTOM. 2 1. LOCATIONOF MOUNTING NUTS 2. WINDOW WINDING REGULATOR 3. LOCATION OF MOUNTING SCREWS 2 3 1 Fig. 16. 1. MOUNTINGSCREWS BOTTOM (REARDOOR) 2. WINDOWWINDINGREGULATOR 3 2 1 REAR LH DOOR 4