SAFARI

27 ANTI-LOCK BRAKES ABS 5. Replace toner ring if any teeth are missing or damaged. Installation of Front wheel speed sensor 1. Clean speed sensor and its mounting surface. 2. Anchor both the sensor grommets to the stub axle & to the long member. 3. Route the cable properly. 4. Install the wiring harness connector with wheel speed sensor cable. 5. Make sure that the sensor cable connector is fully seated and locked into vehicle wiring harness connector. Fig. 22 6. Insert the sensor into the sensor mounting hole and fit it to the front stub axle by butting it against the face on the stub axle and tighten the bolt to the specified torque. Fig. 21 7. Check the air gap between the face of the wheel speed sensor and the top surface of the toner wheel. Air gap: 0.35 to 1.65 mm 8. Road test vehicle to ensure proper operation of the basic and ABS brake system. Fig. 21 Fig. 22