SAFARI

PROPELLER SHAFT 7 Fig. 8 Fig. 9 Fig. 10 Remove snap ring from yoke. Turn joint over, tap bearing away from snap ring, then remove opposite snap ring. Fig. 8 Set the yoke in the arbor press with a piece of tube stock beneath it. Position the yoke with the tube fitting bearing up to prevent inter ference during disassembly. Place a solid plug on the upper bearing assembly and press it through to release the lower bearing assembly. Fig. 9 If the bearing assembly will not pull out by hand after pressing, tap the base of the lug near the bearing assembly to dislodge it. To remove the opposite bearing assembly, turn the yoke over and straighten the cross in the open cross hole. Then carefully press on the end of the cross so the remaining bearing assembly moves straight out of the bearing cross hole. Fig. 10 Repeat this procedure on the remaining bearing assemblies to remove the cross from the yoke.