SAFARI

ENGINE 66 Fig 1 Fig 2 Procedure For Removal Sedimenter (Old type) Removal 1. Remove the upper engine cover. 2. Further clean the sedimenter, its connections, and the surrounding area. 3. Disconnect the water sensor electrical connector. 4 Disconnect the fuel tank to sedimenter supply pipe and plug the pipe and port with appropriate plug. (Fig: -1) 5. Remove the quick fit connectors from sedimenter to fuel filter and plug the pipe and port with appropriate plug. (Fig: - 2) 6. Loosen and remove the M8 bolt with a suitable ratchet spanner of the fuel filter and sedimenter mounting bracket. 7. Lift the filter / Sedimenter. Follow the draining procedure above till the point 5 (keep water sensor) then l Wait until all fuel water drained out of the water sedimentor. l Remove the water sedimentor from the vehicle. Then follow the installation procedure given below. Installation The installation procedure is as follow 1. Place the water sedimentor in the bracket, the 2 protecting caps still in place. 2. Avoid any spillage on the water sedimentor while hydraulic connectors are not fitted. 3. Tighten the sedimenter on the bracket in the required conditions. Identify inlet (printed arrow going forward to the port), outlet (printed arrow going outward to the port) ports on the water sedimenter. 4. Remove the protecting cap and clip the inlet hydraulic connector. Do not force or bend the pipe. 5. Remove the protecting cap and clip the outlet hydraulic connector. Do not force or bend the pipe. 6. Screw the water sensor to the required torque 7. Clip the electric connector to the water sensor. 8. Check that there is no leakage after assembly. 9. After starting the engine, check to make certain that the sedimenter warning light is off. NOTE Fitting of sedimenter : It is important to specify that it must be fitted correctly (i.e. vertical with no angle) to avoid possible damage due to it vibrating against metallic attach that could cause GO leaks.