SAFARI

58 GEAR BOX G-76 Fi t clutch release bearing and release fork. Ref Fig. 130 Fig. 130 Lift and mount the gear box at cylinder block face, aligning drive shaft splines with clutch plate using a dummy main shaft. Align the clutch plate to center hub splines, first hand tight the diagonally opposite bolts then tighten all the bolts to required torque. Clear the gear shift lever through opening provided on the cab. Tighten all mounting bolts of clutch housing to required torque. Apply grease over supporting pin of extension armand also inside rubber bush of extension arm support. Slide support over pin. Fit extension arm support on cross member. Tighten nyloc nut alongwithwasher such as tomaintain a clearance of 10 mm between extension arm stud end and propeller shaft. Fig. 131 Fit - Clutch slave cylinder and its piping. - Speedo cable - Reverse indicator switch connector Fig. 131 - Propeller shaft Fix rubber seal in its seat over tunnel cut out and over plate, tighten screws along with washer. Slide rubber bellow over collar of cover plate.