SAFARI

52 GEAR BOX G-76 Insert selector shaft from bottom through selector lever aligning rollers with its splines. Then pass it through selector & shifter finger and ensure that notch at end is facing towards detent. (To be fitted afterwards). Fig. 115 Align hole of selector shaft and selector & shifter finger. Fit spiral pin. Locating swing lever betweenunder cut of reverse shifter shaft and shifter shaft Reverse/5th. Ensure that notch on the lever is at the top and towards reverse shifter shaft. Fit circlip to pin, if removed earlier. Insert pin through bearing block and swing lever. Fig. 115 Fit Reverse Idler gear shaft assembly in the housing such that reverse gear collar is at top. Ref Fig. 116 Fig. 116 Tighten hex screw along with bright washer and spring washer to hold Reverse Idler shaft in the housing - rear. Ref fig. 117 Fig. 117